- Simple one punch installation with our punch tool (included)
- Universal Design suitable for every ute model
- High Quality UV resistant nylon stretch cord and plastic base
- Corrosion Resistant 316 Stainless Steel Eyelet Rivets
- Complete Convenience with our Do It Yourself installation pack including rivets and tool
- Buy with Confidence knowing this product has been supplied for over 50 years to trade, commercial and industrial customers
- Perfect for Utes covers, boat covers, storm covers, sand pit covers, eskys, kayaks, boats and bikes.
- The loops are made from high quality UV resistant nylon stretch cord and they offer excellent durability
- Bunji loop buttons are available for separate purchase
How to measure bungee loops?
Length is measured from the middle of the fixing hole to the top of the loop when pinched together. Loops have around 10-15% stretch in them.
Bungee Loops
- Base Height: 10mm
- Base Width: 27mm x 15mm
- Hole Diameter: 4mm
- Cord Diameter: 6mm
- Fixing hole insert caps not included
Rivets
- Material: 316 Stainless Steel
FAQs
Length is measured from the middle of the fixing hole (where it attaches) to the end of the loop when pinched together.
Loops have around 10-15% stretch in them
The most common way is to drill out the fixing. Use a drill bit that is equal, or slightly less than the size of the fixing hole.
When adding or replacing loops on a tonneau, you'll need hard surface (like a block of timber) and a hammer. Place the eyelet through the underside of the cover in the position that you need the loop, and through the loop on top. You may need to make a small hole in the cover if you’re not using an existing hole. Place the rivet over a hard surface (like a block of timber) so you don’t damage the vehicle/underside of the loop location. Insert the punch into the top of the rivet, then hit the punch with a hammer 1-2 times so the top of the rivet rolls out to lock in the loop.
Need further assistance? Please reach out to us!